7
4
Installation
This chapter introduces the installation requirements, preparations, and installation procedures.
Safety Instructions
WARNING
Strictly confirm to requirements in the manual during installation; otherwise we will not be
responsible for any loss occurred.
Incorrect installation or improper operation might bring damages to humans or objects.
Security devices and control devices used must confirm to EN12978.
Before installing, wiring, and disassembling the turnstile, unplug the power supply first.
The turnstile consists of various mechanical and electrical devices, any negligence during
installation might cause damage.
In case of smoke, unpleasant odor, or strange noise, unplug the turnstile immediately, and then
contact technical support.
Pay extra attention when you are operating inner components that are electrically charged or can
cause the arms to move.
Do not disassemble the turnstile unless necessary; otherwise, people injury or property damage
might occur.
Firmly fix the turnstile.
Make sure that the ground cable works properly before powering on the turnstile.
Before making the turnstile operational, make sure that people can see the turnstile completely
and clearly to avoid injury.
Do not operate the turnstile in the passage after it is powered on.
Preparations
Make sure that the turnstile is installed on a flat surface.
If the turnstile is to be installed outdoors where water pooling is likely to occur, it must be installed
on a 50 mm–150 mm (adjust according to the actual situation) cement base. The passage also
should be elevated to the same height of the cement base. Apply silicon sealant to the gap
between the cement base and the turnstile to keep out water and condensation.
Make sure that the PVC pipe is buried more than 60 mm under the ground, and the height of the
PVC pipe above the ground should be more than 50 mm. Bend the PVC pipe end that is above
the ground to keep out water. Keep the installation surface dry.
Clean the installation surface.
Confirm the installation position.
