15
4.3.3
Fixing the Turnstiles
After adjusting the turnstile position, put a M12 flat gasket, M12 spring gasket, and a M12 nut
on the expansion bolt, and then manually tighten the nut.
Tighten all the nuts with a wrench.
Apply silicone sealant to the gap between the turnstile and the ground to avoid water leakage.
Fix the turnstiles
4.3.4
(Optional) Drilling for a Face Recognition Access Controller
If you need to install a face recognition access controller, you need to drill a hole on the top cover of
the turnstile.
Prerequisite
Installation of the turnstile is complete.
The turnstile works normally during commissioning. See "6 Commissioning".
Power off the turnstile.
Procedure
Open the top cover, and then lay a piece of paper over all the inner components to prevent
the iron dust from damaging them.
Use a marker to mark down the position for drilling.
