5
4
Installation
This chapter introduces the installation requirements, preparations, and installation procedures.
Safety Instructions
4.1
WARNING
Strictly conform with the requirements of the manual during installation, otherwise we will not
be responsible for any loss occurred.
Incorrect installation or improper operation might bring damages to humans or objects.
Security devices and control devices used must confirm to EN12978.
Before installing, wiring, or disassembling the turnstile, unplug the power supply first.
The turnstile consists of various mechanical and electrical devices, any negligence during
installation might cause damage.
In case of smoke, unpleasant odor, or strange noise, unplug the turnstile immediately, and then
contact technical support.
Pay extra attention when you are operating inner components that are electrically charged or
can cause the arms to move.
Do not disassemble the turnstile unless necessary, otherwise people injury or property damage
might occur.
Firmly attach the turnstile.
Make sure that the ground cable works properly before powering on the turnstile.
Before making the turnstile operational, make sure that people can see the turnstile completely
and clearly to avoid injury.
Do not operate the turnstile while standing in the passage when it is powered on.
Preparations
4.2
Make sure that the turnstile is installed on a flat surface.
If the turnstile is to be installed outdoors where water pooling is likely to occur, it must be
installed on a 50 mm–150 mm cement base (adjust according to the actual situation). The
passage also should be elevated to the same height of the cement base. Apply silicon sealant to
the gap between the cement base and the turnstile to keep out water and condensation.
Make sure that the PVC pipe is buried more than 60 mm under the ground, and the height of
the PVC pipe above the ground should be more than 50 mm. Bend the PVC pipe end that is
above the ground to keep water out. Keep the installation surface dry.
Clean the installation surface.
Confirm the installation position.