11
Open the top panel
Figure 4-9
Tug all the cables inside the turnstile through the cable entry, and keep them organized to
Step 2
avoid damage.
Cable entry
Figure 4-10
Carefully lift the turnstile up and adjust its position, overlap the holes on the turnstile with
Step 3
the expansion bolts, and then place the turnstile on the ground.
Use gaskets to level the turnstile.
Step 4
Mark three evenly separated points on the installation surface horizontally or vertically
Step 5
along the turnstile. Use a gradienter to measure the angle of inclination of the three points.
See the figure below for the acceptable flatness error.
