12
Acceptable flatness error
Figure 4-11
Repeat Step 1–Step 5 to install other turnstiles.
Step 6
The arms of different turnstiles must face the same direction.
Make sure that the turnstiles are aligned within deviation.
Align the turnstiles within deviation (mm[inch])
Figure 4-12
4.3.3
Fixing the Turnstiles
After adjusting the turnstile position, put an M12 flat gasket, M12 spring gasket, and an M12
Step 1
nut on the expansion bolt, and then manually tighten the nut.
Tighten all the nuts with a wrench.
Step 2
Apply silicone sealant to the gap between the turnstile and the ground to avoid water
Step 3
leakage.
