24
Maintenance Cycle
Appendix 1
Maintain the turnstile regularly to ensure long service life.
Cleaning the Surface
Maintenance cycle for a good environment (adjustable according to the on-site environment):
Outdoor: Once every five days, and every time after it rains.
Indoor: Once every seven days.
Maintenance content: Clean the surface and the arms.
Use a piece of soft cloth soaked with a neutral detergent or clean water, and then clean the
surface and arms of the turnstile. If the turnstile is covered in rain, clean after it is dry.
High salinity and humidity environment, acid rain, and sweat will corrode the surface made
of stainless steel. Use scour pads to clean the rust first (you can also use rust remover at the
same time), and then use a piece of soft cloth soaked in a neutral detergent or clean water
to clean the surface and arms of the turnstile.
Cleaning the Interior
Do not use water to clean the interior, otherwise a short circuit might occur.
Once every three months.
Maintenance content:
Disconnect the power supply, open the top panel, and then remove the dust inside the
turnstile.
Make sure that the motor, bearing, fastening pieces, connection bars, and screws are all
tightened.
Apply anti-corrosive lubricant to the bearing rods, gears, and other moving parts.
Check if there are any loose connections. If yes, wrap the cables together, tighten the
connectors, or follow any other similar measures that should be applied. Replace bad
cables if any.
Regularly check if all the functions are normal.
