User’s Manual
8
Use M12 expansion bolts. Make sure that the thread length of expansion bolt is more
than 80 mm (3.15''), and its total length is more than 150 mm (5.91'').
Install expansion bolt (top view) (mm [inch])
Figure 3-4
Thread the power cable and the signal cable separately through two 1-inch PVC pipes
(buried in the foundation) to the cable holes next to the foundation.
After installation, make sure that when opening the Barrier, there are no obstacles within a
90° vertical range.
Installing Barrier
3.2
3.2.1 Before You Start
Read the manual carefully before installation. Refer to the barrier drawing attached to the
casing to know the working method of the Barrier and its wiring.
Check whether the power cable, signal cable, or internal wiring is loose or dropped. If yes,
connect the cables well before installation.
Lane
Use M12 expansion bolt. Leave the bolt
100mm (3.9'') above the ground surface
Barrier arm
Vehicle movement direction
