31
Please note:
Slight difference may be found in the user
’s interface, due to various protocols.
Please make sure the speed domes A/B cables are properly connected to the A/B ports of
DVR.
You have properly set PTZ information.
Please switch camera monitor channel to current window.
2.8.1 PTZ Setup
The pan/tilt/zoom setup includes the following items. Please select channel first. See Figure 2-28.
Protocol: Select corresponding PTZ protocol such as PELCOD.
Address: Input corresponding PTZ address.
Baud rate: Select baud rate.
Data bit: Select data bit. Default value is 8.
Stop bit: Select stop bit. Default value is 1.
Parity: There are three choices: none/odd/even. Default value is none.
Figure 2-28
After completing all the setups please click save button, system goes back to the previous menu.
2.8.2 PTZ Operation
In one window display mode
, right click mouse (click “Fn” Button in the front panel or click
“Fn” key in the remote control). The interface is shown as in Figure 2-29.
Figure 2-29
Click Pan/Tilt/Zoom, the interface is shown as below. See Figure 2-30.
Here you can set the following items:
Step: value ranges from 1 to 8.
