88
In
472H472H
Figure 6-5, click pattern button and then click begin button. The interface shows
like
473H473H
Figure 6-9.
Please go to
474H474H
Figure 6-2 to modify zoom, focus, and iris. Go back to
475H475H
Figure 6-9 and
click end button.
You can memorize all these setups as pattern 1.
Figure 6-9
6.2.6 Activate Pattern Function
In
476H476H
Figure 6-6 input mode value in the No. blank, and click pattern button.
6.2.7 Border
Setup
In
477H477H
Figure 6-5, click border button. The interface is shown as in
478H478H
Figure 6-10.
Please go to
479H479H
Figure 6-2, use direction arrows to select camera left limit, and then
please go to
480H480H
Figure 6-10 and click left limit button
Repeat the above procedures to set right limit.
Figure 6-10
6.2.8 Activate Border Function
In
481H481H
Figure 6-6, click auto scan button, the system begins auto scan. Correspondingly,
the auto scan button changes to stop button.
Click stop button to terminate scan operation.
6.2.9 Flip
In
482H482H
Figure 6-6, click page switch button, you can see an interface is shown as below.
See
483H483H
Figure 6-11. Here you can set auxiliary function.
Click page switch button again, system goes back to
484H484H
Figure 6-2.
