3.2 Model B
Figure 3-3
Installation of model B
Step 1 Rotate the camera mounting bracket
①
outwards and open it.
Clamp it to the mounting surface
②.
Adjust the camera to the
ideal angle.
Step 2 Connect the USB camera to computer with USB cable.
When the device works normally during a video call, the blue
indicator will turn on.
Appendix 1 Maintenance
In order to maintain the image quality and proper functioning of the
device, please read the following maintenance instructions carefully
and hold rigid adherence.
Maintaining Lens and Mirror Surface
The lens and mirror surface are covered with antireflection coating,
which could be contaminated or damaged and result in lens scratches
or haze image when being touched with dust, grease, fingerprints and
other similar substances. Please refer to the following methods to deal
with once dirt is found:
●
Stained with dirt
Use oil-free soft brush or hair dries to remove it gently.
●
Stained with grease or fingerprint
Use soft cloth to wipe the water drop or oil gently to make it dry,
then use oil-free cotton cloth or paper soaked with alcohol or
detergent to wipe from the lens center to outward. It is ok to change
the cloth and wipe several times if it is not clean enough.
Maintaining Device Body
●
Device body can be cleaned with soft dry cloth, which can also
be used to remove stubborn stains when moistened with mild
detergent.
●
To avoid possible damage on device body coating which could
cause performance decrease, do not use volatile solvent such as
alcohol, benzene, diluent and so on to clean the device body, nor
can strong, abrasive detergent be used.
