29
Figure 4-7
2. Please draw a circle to enable corresponding function.
Double click current item to go to setup interface. Refer to chapter 4.3.2 Network
Service for detailed information.
3. Click Save button.
Step 4 Click Save button.
4.1.4
General Information
It is to set device basic information and some general settings such as system time, date format,
language.
Step 1 On the main menu, from Setting->General,
Enter General interface. See Figure 4-8.
Step 2 Set parameters.
System time: Here is for you to set system time
Note
Since system time is very important, do not modify time casually unless there is a
must!
Before your time modification, please stop record operation first!
Date format: There are three types: YYYYY-MM-DD: MM-DD-YYYYY or
DD-MM-YYYY.
Date separator: There are three denotations to separate date: dot, beeline and
solidus.
DST: Here you can set DST time and date. Please enable DST function and then
click set button. You can see an interface is shown as in Figure 4-9. Here you can
set start time and end time by setting corresponding week setup. In Figure 4-9,
enable date button, you can see an interface is shown as in Figure 4-10. Here you
can set start time and end time by setting corresponding date setup.
