48
connected peripheral device supports this function. Select wiper from the dropdown list
and click On to turn the wiper on and click Off to turn the wiper off.
It is to use RS485 command to control the peripheral device heater module on/off. Make
sure the connected peripheral device supports this function. Select defrost (clear fog) from
the dropdown list and click On to turn the heater on and click Off to turn the heater off.
Aux number: Input auxiliary number and then click On to start the auxiliary function. Click Off
to stop auxiliary function.
Figure 4-34
4.2.2.6 PTZ Menu Operation
If the connected camera supports PTZ menu function, you can enable PTZ menu function to set
and control the connected camera.
Preparation
Set the PTZ protocol as HD-CVI, baud rate is 2400. Refer to chapter 4.2.2.1 PTZ settings for
detailed information.
Step 1 On PTZ interface (Figure 4-34), click Pg Switch for three times.
Enter the following interface. See Figure 4-35.
Figure 4-35
