65
4.3.2.4 Ethernet port 2
It is to set Ethernet port 2 IP address, subnet mask and default gateway.
Step 3 On the main menu, from Setting->Network,
Enter Network interface.
Step 4 Click Network service,
Enter network service interface.
Step 5 Set Ethernet port 2.
1. Double click Ethernet port 2.
Enter Ethernet port 2 interface. See Figure 4-55.
Figure 4-54
2. Input IP address, subnet mask, default gateway.
3. Click OK.
Step 6 Select Ethernet port 2 and then click Save.
Enter Network interface.
Step 7 Click Save button.
4.3.2.5 P2P
You can use cellphone client or the management platform to access the device.
You can use your cell phone to scan the QR code and add it to the cell phone client.
Via the SN from scanning the QR code, you can access the device in the WAN. Please refer
to the P2P operation manual included in the resources CD.
Preparation
Make sure the device has connected to the network.
Cellphone has downloaded and installed the corresponding client such as DMSS.
Step 1 On the main menu, from Setting->Network,
Enter Network interface.
Step 2 Click Network service,
Enter network service interface.
Step 3 Configuring P2P.
