67
Figure 4-56
Step 4 Click Apply or Save to complete setup.
Enter Network interface.
Step 5 Click Save button.
4.3.2.6 Network Test
It is to view network status and loading.
4.3.2.6.1 Network Test
It is to test network status and view network average delaying and packet loss rate.
Step 1 On the main menu, from Info->Network->Network test,
Enter Network test interface. See Figure 4-57.
Step 2 Set parameters.
Destination IP: Please input valid IPV4 address and domain name.
Test: Click it to test the connection with the destination IP address. The test results
can display average delay and packet loss rate and you can also view the network
status as OK, bad, no connection and etc. See Figure 4-58.
Network Sniffer backup: Please insert USB2.0 device and click the Refresh button,
you can view the device on the following column. You can use the dropdown list to
select peripheral device. Click Browse button to select the snap path. The steps
here are same as preview backup operation.
Figure 4-57
