Dahua iDVR&iHCVR
User’s Manual
187
The multicast interface is shown as in Figure 5-41.
Multicast is a transmission mode of data packet. When there is multiple-host to receive the
same data packet, multiple-cast is the best option to reduce the broad width and the CPU
load. The source host can just send out one data to transit. This function also depends
on the relationship of the group member and group of the outer.
Figure 5-41
5.9.2.15 Auto Register
The auto register interface is shown as below. See Figure 5-42.
This function allows the device to auto register to the proxy you specified. In this way, you
can use the client-end to access the DVR and etc via the proxy. Here the proxy has a
switch function. In the network service, device supports the server address of IPv4 or
domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please
enable the auto register function, the device can auto register to the proxy server.
Figure 5-42
5.9.2.16 Alarm Centre
The alarm centre interface is shown as below. See Figure 5-43.
This interface is reserved for you to develop. System can upload alarm signal to the alarm
centre when local alarm occurs.
Before you use alarm centre, please set server IP, port and etc. When an alarm occurs,
system can send out data as the protocol defined, so the client-end can get the data.
Summary of Contents for iDVR&iHCVR
