28
End Time
2.
According to the local regulations, configure the type, begin time and end
time for the DST.
Timing
Mode
Select a timing mode, including DSS, GPS, and NTP. The default selection is NTP
DSS
: The system time syncs with DSS platform.
GPS
: The system time syncs with satellite.
NTP
: The system time syncs with NTP server that you configured.
Server
Address
In the
Timing Mode
list, if
NTP
is selected, configure this parameter.
After configuring NTP server, the Recorder syncs time with NTP server.
1.
In the
Timing Mode
list, select
NTP
to enable the NTP timing function.
2.
Configure parameters.
Server Address: Enter IP address of NTP server.
Manual Update: Click
Manual Update
to sync the Recorder time with
NTP server.
Port: The system supports TCP protocol only and the default setting is
123.
Interval: Enter the interval that you want the Recorder to sync time with
the NTP server. The maximum value is 65535 minutes.
Manual
Update
Port
Interval
Click
OK
.
Configuring Remote Recorders
This section describes how to add cameras to channels. Connect the IPC to the Ethernet port on the
rear panel of the Recorder. You can use a holder or tie strap to fix the port.
3.6.1
Initializing the Remote Recorder
Only the initialized remote Recorder can be added. If the remote Recorder that you want to add has
been initialized, ignore this section.
Preparation
Make sure the remote Recorder supports initialization.
Procedure
Select SETTING > CAMERA > CAMERA LIST.
The
Camera List
interface is displayed. See Figure 3-8.
