16
2.3.4
Fixing the Recorder
Install the Device on the vehicle where it cannot be seen from outside. Avoid places with high
temperature or near the air conditioning system. High temperature shortens the life of the
Device. If going into the Device, the condensing water from the air conditioner can short circuit
or burn the Device.
Power on the Device only after all external devices are connected correctly to the Device.
Install lugs onto the Device.
1)
Place washers onto the fixing screw.
2)
Use fixing screws with washers, mount lugs to the bottom of the Device respectively,
and tighten the lugs.
Install the lugs onto the Device.
Fix the device onto the vehicle.
1)
Punch holes on the vehicle according to the installation dimensional drawing.
2)
Use screws to fix the Device onto the vehicle.
Fix the Device onto the vehicle.
Connect cables to the Device.
Check the voltage of the accumulator. The working voltage of this Device ranges from
6V to 36V. To make sure the Device works stably, directly get power supply from the
accumulator.
When installing the basic wires, do not use excessive force to pull the control wires.
2.3.5
Connecting to Power Cables
Before connecting the power cable, confirm whether the input voltage is between 6V DC and
36V DC. If it is out of the range, it will damage the device.
