22
3
Basic Settings
This Recorder can be operated following instructions on the local interface or web interface. This
section introduces the web interface instructions. The Local interface is similar and would not be
elaborated here.
Browsers including Safari, Firefox, and IE are supported.
Booting up Recorder
Before booting up the Recorder, check if input voltage matches rated voltage of the Recorder.
Refer to international standard to offer the power input (power input that is with stable power
value and less interference) to ensure the Recorder works stably and prolong its service life.
In the first power-on, the Recorder needs connection to the ACC to work as intended.
Rotate the Recorder key to
and rotate the vehicle key to ACC position. The power indicator is on,
and the Recorder is ready for work.
For the first boot up or after restoring to the default factory settings, the initialization interface is
displayed on the screen. Follow on-screen instructions to initialize your Recorder prior to use.
Initializing Recorder
When you are opening the Recorder for the first time or you have allowed your system to be restored
the factory settings, you need to initialize the Recorder. Only after that can you operate and
configure your Recorder.
Preparation
Please make sure the correct network connection between PC and the Recorder.
Procedure
Open the browser, enter the Recorder IP address (the default IP address is 192.168.1.108),
and then press Enter.
The
Device Initialization
interface is displayed.
