57
Disk
Select the event type, and select
Enable
to enable the handling of corresponding abnormal
events.
Configure more settings. See Table 5-3.
Table 5-3
Abnormality setting parameters
Parameter
Description
Event type
You can configure corresponding abnormal events on the following three tabs.
HDD: To set the ways to handle abnormal HDD events, including No HDD,
HDD Errors, HDD No Space.
User: Set the ways to handle illegal login events.
Device: Set the ways to handle abnormal device events, including
Temperature Too High, Low Battery Safety Exception, Network Security
Exception, Over Speed, Low Speed, Collision, Turnover, Rapid Turn, Rapid
Speedup, Sharp Brake and ACC Power Off.
The event type might be different depending on the model you purchased, and
the actual interface shall prevail.
Lower Than
Select
Disk
tab, and if the
Event Type
is
Low Space
, configure this parameter.
You can set the percentage of Disk remaining space. When Disk remaining space
is lower than this percentage, an alarm will occur.
Login
Attempt
Select
User
tab, and if the
Event Type
is
Illegal Login
, configure this parameter.
The maximum number of allowed password input errors during user login. If the
number of password input errors reaches this value, the user account will be
locked.
Lock time
Select
User
tab, and if the
Event Type
is
Illegal Login
, configure this parameter.
Set the time for locking the user account when the number of password input
errors reaches the set value.
High
Temperature
Select
Device
tab, and if the
Event Type
is
High Temperature
, configure this
parameter.
Enter the upper limit of device temperature. The alarm is triggered when the
device temperature exceeds this value.
Lower Than
Select
Device
tab, and if
Event Type
is
Battery Low Voltage
, configure this
