Device Installation 22
3.3 About Front Panel and Rear Panel
The model number in the stick on the bottom of NVR is very important; check according to your purchase
order.
The label in the rear panel is very important too. Usually we need you to represent the serial number
when we provide the service after sales.
3.4 HDD Installation
For the first time installation, make sure whether the HDD has been installed or not. We recommend to
use HDD of enterprise level or surveillance level. It is not recommended to use PC HDD.
Shut off the power before you replace the HDD.
Use the dedicated SATA HDD for monitoring recommended by the HDD manufacturer.
You can refer to the Appendix for HDD space information and recommended HDD brand.
3.4.1 NVR58-I/54-16P-I/4832-I/4416-16P-I/4432-I Series
Different models have different HDD numbers. The actual product shall prevail.
Remove the fixing screws on the rear panel of the device.
Figure 3-1
Remove the case cover along the direction shown in the following arrow.
Figure 3-2
Remove the screws on the sides of HDD bracket to take out the bracket.
1.5U device has one HDD bracket. For the way to remove the bracket, see Figure 3-3
2U device has two HDD brackets. For the way to remove the brackets, see Figure 3-4.
