service, device supports the server address of IPv4 or domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please enable the auto
register function, the device can auto register to the proxy server.
Figure 4-37
4.8.2.12 Alarm Centre
From main window->Setup->Network->Alarm centre, the alarm center interface is shown as below. See
This interface is reserved for you to develop. System can upload alarm signal to the alarm center when
local alarm occurs.
Before you use alarm center, please set server IP, port and etc. When an alarm occurs, system can send
out data as the protocol defined, so the client-end can get the data.
Figure 4-38
4.8.2.13 HTTPS
From main window->Setup->Network->HTTPS, you can see an interface shown as in Figure 4-39. In this
interface, you can set to make sure the PC can successfully login via the HTTPS. It is to guarantee
164
Summary of Contents for NVR6000 Series
