Figure 4-107
4.8.6.2 Slave Device
When you add the first slave device , the default IP is the device IP address that logins in the WEB.
From main menu->Setup->Cluster service->Slave device, you can go to the following interface. See
Figure 4-108. You can refer to Chapter 4.8.6.1 to set.
Figure 4-108
After you added master device and slave device , you need to enable cluster function. Otherwise, cluster
function is null. Please refer to chapter 4.8.6.4.
4.8.6.3 Record Transfer
From main menu->Setup->Cluster service->Record transfer, you can go to the record transfer interface.
When the master device is malfunction and can not record, system can use slave device to record
instead. You can use this function to forward the record files on the slave device to the main device.
After the master device is malfunction, the slave device becomes active and status is used.
After the master device becomes active again, there is a
button on the left side of the master device
205
Summary of Contents for NVR6000 Series
