Local Configurations
146
5.10.3
Face Detection
You can configure the face detection settings and search the detected faces in the defined time
period.
5.10.3.1
Configuring Face Detection Settings
When the Device detects the human faces, the system activates alarms.
Not all models support this function.
Smart IPC must be equipped with face detect function.
Select
Main Menu > FACE DETECT > Parameters
.
The
Human Face
interface is displayed. See Figure 5-127.
Configure the settings for the face detection parameters. See Table 5-41.
Parameter
Description
Channel
In the
Channel
list, select a channel to set the face detection.
Target Filter
Click
Setting
to draw areas to filter the target.
You can configure two filtering targets (maximum size and
minimum size). When the target is smaller than the minimum size
or larger than the maximum size, no alarms will be activated. The
maximum size should be larger than the minimum size.
Enable
Enable or disable the face detection function.
Summary of Contents for Smart 1U
