Local Configurations
157
Parameter
Description
Show Message
Select the
Show Message
check box to enable a pop-up message in
your local host PC.
Alarm Upload
Select the
Alarm Upload
check box to enable the system to upload the
alarm signal to the network (including alarm center) when an alarm
event occurs.
Send Email
Select the
Send Email
check box to enable the system to send an
email notification when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main
Menu > NETWORK > EMAIL
.
Record Channel
Select the channel(s) that you want to record. The selected channel(s)
starts recording after an alarm event occurs.
The recording for alarm and auto snapshot must be enabled. For
details, see "5.1.4.9 Configuring Recorded Video Storage Schedule"
and "5.9.1 Enabling Record Control."
PTZ
Click
Setting
to display the PTZ interface.
Enable PTZ activation function. For each PTZ camera, select the
preset that you want to be called when an alarm event occurs.
Post Record
Set a length of time for the Device to delay turning off recording after
the alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Tour
Select the
Tour
check box to enable a tour of the selected channels.
To use this function, make sure the tour is enabled and configured in
Main Menu > DISPLAY > TOUR
.
Snapshot
Select the
Snapshot
check box to take a snapshot of the selected
channel.
To use this function, make sure the following settings are configured:
The snapshot function is enabled for motion detect alarms in
Main
Menu > STORAGE > SCHEDULE > Snapshot
.
Select
Main Menu > CAMERA > ENCODE > Snapshot
, in the
Mode
list, select
Event
.
Video Matrix
Select the check box to enable the function. When an alarm event
occurs, the video output port outputs the settings configured in "
Main
Menu > DISPLAY > TOUR
."
Not all models support this function.
Buzzer
Select the check box to activate a buzzer noise at the Device.
Log
Select the check box to enable the Device to record a local alarm log.
Voice Prompts
Select to enable audio broadcast/voice prompts in response to a local
alarm event.
Click
Apply
to complete the settings.
Summary of Contents for Smart 1U
