Local Configurations
38
Parameter
Description
NTP
Enable the NTP function to sync the Device time with the NTP server.
Server
In the
Server
box, enter the IP address or domain name of the
corresponding NTP server.
Click
Manual Update
, the Device starts syncing with the server
immediately.
Port
The system supports TCP protocol only and the default setting is 123.
Interval (Min.)
In the
Interval
box, e
nter the amount of time that you want the Device to
sync time with the NTP server. The value ranges from 0 to 65535.
5.1.4.4
Configuring Network Settings
You can configure the basic network settings such as net mode, IP version, and IP address of
the Device.
You can also configure network settings by selecting
Main Menu > NETWORK > TCP/IP
.
After you have configured the date and time settings, on the
Date&Time
interface, click
Next
.
The
NETWORK
interface is displayed. See Figure 5-15.
Configure the settings for network parameters. See 0.
Parameter
Description
Net Mode
Multi-address
: Two Ethernet ports work separately through either
of which you can request the Device to provide the services such
as HTTP and RTSP. You need to configure a default Ethernet port
(usually the Ethernet port 1 by default) to request the services from
the device end such as DHCP, Email and FTP. If one of the two
Summary of Contents for Smart 1U
