INSPECTION OF FRONT BRAKE RUBBER PARTS AND
BRAKE PAD FOR DAMAGE
1. Jack up the vehicle and support the vehicle with safety
stands.
2. Remove the front wheel.
3. Remove the sub-cylinder slide pins.
MA–30
4. Turn up the disc brake assembly as shown.
CAUTION :
·
Never pull the brake hoses not more than necessary.
5. Ensure that no damage exists on the cylinder boot.
If any damage exists, replace the cylinder boots and pis-
ton seal with new ones as a set.
(Refer to the BR section.)
6. Ensure that no leakage of brake fluid exists from the disc
brake cylinder, piston and around the cylinder boot.
If any leakage exists, replace the piston seal and cylinder
boot with new ones.
(Refer to the BR section.)
7. Inspect the disc pads and disc brake pad-related parts
for damage.
If any damage is found, replace the damaged part, as re-
quired.
(Refer to the BR section for details.)
8. Ensure that no damage exists on the disc brake pad
guide plates, disc brake pad guide No. 2 plates, disc
pads, shims and anti-squeal shims.
If any damage exists, replace the damaged parts with
new ones.
9. Install the disc brake pad guide plates, disc brake pad
guide No. 2 plates, disc pads, shims and anti-squeal
shims as shown.
CAUTION :
·
Prior to installation, apply brake grease to the sliding
surface of the component parts.
10. Ensure that no damage exists on the pin boots.
If any damage is present, replace the pin boots with new
ones.
(Refer to the BR section.)
JMA00084-00065
JMA00085-00066
JMA00086-00067
