MUFFLER AND EXHAUST PIPE
DAMAGE & TIGHTNESS
1. Visually check that the exhaust pipes and mufflers for
damage and exhaust gas leakage. Also ensure that there
is no possibility of interference with any other parts.
WARNING
·
Never perform this check when the exhaust system is
hot.
If any damage or gas leakage exists, repair or replace the
parts as necessary.
2. Check that the muffler support of the exhaust pipe and
muffler as well as their connecting section for looseness,
using a suitable wrench or rock them by hand.
WARNING:
·
Never perform this check when the exhaust system is
hot.
·
Be careful not to burn yourself during inspection.
If any damage or looseness is found, repair or replace
parts as necessary.
AUTOMATIC TRANSMISSION
FLUID CHANGE
1. Place a suitable container under the drain plug.
2. Drain the transmission fluid by removing the drain plug.
3. Install the drain plug with a new gasket interposed and
tighten the drain plug with the specified tightening torque.
Tightening Torque:
19.6 - 29.4 N·m (2.0 - 3.0 kgf-m)
CAUTION:
·
Never reuse the used gasket.
4. Fill the specified automatic transmission fluid to the auto-
matic transmission.
Specified Automatic Transmission Fluid:
DEXRON
â
@
or
#
Capacity:
1.7 liters (Drain and refill)
5. Check the fluid level.
CAUTION:
·
Inspection should be performed when the fluid temperature is between 70 - 80
°
C.
Be very careful not to scald yourself with hot transmission fluid or other parts in the engine compart-
ment.
(1) Park the vehicle on a level surface and apply the parking brake fully.
(2) With the engine idling, move the shift lever from the P range to the L range, and return it to the P
range.
(3) Pull out the dipstick and wipe it clean. Then insert the dipstick and pull it out again. Ensure that the
fluid level is between the upper and lower levels in the hot range of the oil level gauge.
If the fluid level is less than the lower level, add the specified automatic transmission fluid to the
upper level of the dipstick. Then, recheck the fluid leakage.
MA–37
Catalytic
converter
JMA00104-00083
JMA00105-00000
JMA00106-00084
JMA00107-00000
