－
E16
－
7.5 Connection of conduit
･
Insert the plastic liner into the conduit, fasten the insert nut to the wire guide.
7.6 Feeding Wire by Inching Operation
WARNING
●
Keep away your face, eyes and body
from the top of torch while inching.
Wire may come out and stick to your
face, eyes and body and cause
injured.
CAUTION
●
Keep away your hands, fingers, hair
or clothes from the rotating parts of
the feed roll, etc. to prevent you from
being caught into the rotating parts
while inching.
After straightening the conduit, feed the wire by pressing the INCHING key. When the wire appears from
the end of the wire guide, press the INCHING key again. Cut the wire at about 10mm from the end of the
tip. Wire feed speed can be adjusted by turning the adjusting knob.
7.7 Hanging the Wire Feeder
CAUTION
●
When hanging the wire feeder, firmly fix the
cap knob and clamp screw to prevent the
device from dropping.
●
Do not use the carrying handle of the wire
feeder to hang the wire feeder.
Screw to clamp the cap knob
Hanging bracket (optional)
Carrying handle
Wire guide
Nut
Plastic liner
Conduit
Insert
Fasten
Remote control
Inching switch
