C
ONNECTING
THE
W
ELDING
P
OWER
S
OURCE
C
ONNECTION
C
HAPTER
4
33
Chapter 4
Connection
4.2.2
Connection of wire feeder
This chapter explains the connecting procedure of the wire feeder. Refer also to the instruction manual of wire feeder.
T I P S
•
When using the voltage detection cable, the wiring for the wire feeder or welding power source needs
to be changed. (
-
Wiring of Voltage Detection Cable at Base Metal Side)
1.
Connect the power cable for wire feeder (torch side) to the receptacle.
●
Firmly attach the power cable for torch side by turning the connector in the clockwise direction.
2.
Remove the cap of the socket of wire feeder and insert the control cable (10 cores) to the socket for the wire
feeder.
●
Fit the concave part of the connector and convex part of the socket for secure connection and tighten the knurled
screws in the clockwise direction.
●
When using an analog remote control (optional accessory), remove the cap of socket for analog remote control
and insert the control cable (6 cores).
Connection for wire feeder is complete. Procedure is followed by 4.2.3
CAUTION
•
When not using an analog remote control (optional accessory), do not remove the cap for
the analog remote control.
Welding power source
Socket for the wire feeder
Socket for analog remote
control
Control cable of analog
remote control
(Optional accessories)
Analog remote control
wire feeder
Control cable for
Wire feeder
Receptacle
Connector
Power cable for torch side
Power cable for base
metal side
Power cable for torch side
Cable fixture
