S
ETTING
I
NTERNAL
F
UNCTIONS
W
ELDING
C
ONDITION
C
HAPTER
6
95
Chapter 6
W
elding Condition
Example:
In the setting examples of F29: "5"; F30: "0"; F31: "5"; and f32: "0", the following diagram is available:
•
Before 100 ms of the torch switch ON (start signal "ON"), set the welding condition to "5" for F29 to F32 to read out the
welding JOB No.
•
To switch plural signals at the same time, carry out the operation within 40 ms.
•
From 40 ms before the torch switch OFF (start signal "OFF") to 100 ms after it, do not change the setting of "5".
Secondary condition
current
ON
OFF
1
Primary condition current
5
2
1
㻌
㻌
㻌
OPEN
CLOSE
OPEN
OPEN
CLOSE
OPEN
㻌
䠥䠪
-EXT3
䠅
㻔
F31
䠖䛂
5
䛃䠅
䠥䠪
-EXT1
䠄
F29
䠖䛂
5
䛃䠅
JOB No.
Primary condition
Secondary condition
㻌
Third condition
㻌
Third condition current
More than 100 msec before
torch switch is turned on.
Switch IN-EXT1 and 3
within 40 msec.
Do not change condition within 40 msec
before and 100 msec after torch
switch is turned off.
Torch switch
Gas flow
Output voltage
Wire feeding speed
Welding current
Pre-flow
Post-flow
Anti-stick time
No-load voltage
Slow-down speed
