Daikin Altherma EABH16DA6V, Operation Manual

3 Operation

Operation manual

5

EABH/X16DA+9W + EAVH/9W
Daikin Altherma – Low temperature split
4P556068-1 – 2018.10

Item

Description

 Room

Restriction: 

Only displayed if a room

thermostat is connected to the indoor unit.

Set the room temperature.

 Main zone

Shows the applicable symbol for your main
zone emitter type.

Set the leaving water temperature for the
main zone.

 Additional zone

Restriction: 

Only displayed if there are two

leaving water temperature zones. Shows
the applicable symbol for your additional
zone emitter type.

Set the leaving water temperature for the
additional zone (if present).

 Space heating/

cooling

Shows the applicable symbol for your unit.

Put the unit in heating mode or cooling
mode. You cannot change the mode on
heating only models.

 Tank

Restriction: 

Only displayed if a domestic

hot water tank is present.

Set the domestic hot water tank
temperature.

 User settings

Gives access to user settings such as
holiday mode and quiet mode.

 Information

Displays data and information about the
indoor unit.

 Installer settings

Restriction: 

Only for the installer.

Gives access to advanced settings.

 Commissioning

Restriction: 

Only for the installer.

Perform tests and maintenance.

 User profile

Change the active user profile.

 Operation

Turn heating/cooling functionality and
domestic hot water preparation on or off.

3.2.3

Setpoint screen

The  setpoint  screen  is  displayed  for  screens  describing  system
components that need a setpoint value.

Example:

▪ Room temperature screen

▪ Main zone screen

▪ Additional zone screen

▪ Tank temperature screen

a1

d

+

–

d

e

d

e

c

a2

b1

b2

Possible actions on this screen

Go through the list of the submenu.

Go to the submenu.

Adjust and automatically apply the desired
temperature.

Item

Description

Minimum temperature limit

a1

Fixed by the unit

a2

Restricted by the installer

Item

Description

Maximum temperature limit

b1

Fixed by the unit

b2

Restricted by the installer

Current temperature

c

Measured by the unit

Desired temperature

d

Turn the right dial to
increase/decrease.

Submenu

e

Turn or press the left dial to
go to the submenu.

3.2.4

Detailed screen with values

a

b

a

Settings

b

Values

Possible actions on this screen

Go through the list of settings.

Change the value.

Go to the next setting.

Confirm changes and proceed.

3.3

Space heating/cooling control

3.3.1

Setting the space operation mode

About space operation modes

Depending  on  your  heat  pump  model,  you  have  to  tell  the  system
which space operation mode to use: heating or cooling.

If a … heat pump

model is installed

Then…

Heating/cooling

The system can heat up and cool down a
space. You have to tell the system which
space operation mode to use.

Heating only

The system can heat up a space, but
NOT cool down a space. You do NOT
have to tell the system which space
operation mode to use.

To tell the system which space operation to use, you can:

You can…

Location

Check

 which space operation mode is

currently used

.

Home screen

Set

 the space operation 

mode 

permanently. Main menu

Restrict

automatic changeover

 according

to a monthly schedule.

To set the space operation mode

1

Go to [4.1]: Space heating/cooling > Operation mode

2

Select one of the following options:

▪ Heating: Always heating mode

▪ Cooling: Always cooling mode

▪ Automatic: 

The 

operation 

mode 

changes

automatically  based  on  the  outdoor  temperature.
Restricted  according  to  the  operation  mode
schedule.