Instruction
SiEN18-621
248
System Configuration
•
If a safety device such as a fuse, a breaker, or an earth
leakage breaker frequently actuates, or ON/OFF switch
does not properly work.
Measure: Turn off the main power switch
•
If water leaks from unit.
Measure: Stop the operation.
•
If the display “
” (INSPECTION), “UNIT No.”, and the
OPERATION lamp flash and the “MALFUNCTION CODE”
appears.
Measure: Notify and inform the model name and what the
malfunction code indicates to your Daikin dealer.
II. If the system does not properly operate except for the
above mentioned case, and none of the above
mentioned malfunctions is evident, investigate the
system according to the following procedures.
1. If the system does not operate at all.
•
Check if there is a power failure.
Wait until power is restored. If power failure occurs during
operation, the system automatically restarts immediately
after the power supply recovers.
•
Check if the fuse has blown or breaker has worked.
Change the fuse or set the breaker.
2. If the system stops operating after operating the
system.
•
Check if the air inlet or outlet of outdoor or indoor unit is
blocked by abstacles.
Remove the obstacle and make it well-ventilated.
•
Check if the air filter is clogged.
Ask a qualified service person to clean the air filters (Refer
to MAINTENANCE).
3. The system operates but it does not sufficiently cool
or heat.
•
If the air inlet or outlet of the indoor or the outdoor unit is
blocked with obstacles.
Remove the obstacle and make it well-ventilated.
•
If the air filter is clogged.
Ask a qualified service person to clean the air filters
(Refer to MAINTENANCE).
•
If the set temperature is not proper
(Refer to ADJUSTMENT).
•
If the air flow angle is not proper (Refer to AIR FLOW
DIRECTION ADJUST).
•
If the FAN SPEED button is set to LOW SPEED
(Refer to ADJUSTMENT).
•
If the doors or the windows are open.
Shut the doors or windows to prevent wind from coming in.
•
If direct sunlignt enters the room (when cooling).
Use curtains or blinds.
•
When there are too many inhabitants in the room (when
cooling).
Cooling effect decreases if heat gain of the room is too
large.
•
If the heat source of the room is excessive (when cooling).
Cooling effect decreases if heat gain of the room is too
large.
UNIT No.
C
L
H
OPERATION l
a
mp
IN
S
PECTION
di
s
pl
a
y
INDOOR UNIT
No. in which
a
m
a
lf
u
nction occ
u
r
s
MALFUNCTION CODE
Summary of Contents for BPMKS967B2B
