5
■
English
4 Pass the wire harness through the hole and insert the
cover into its position and screw it.
Clamp for
positioning
Clamp the wire harness
to the hook next to the
positioning clamp.
Stick the sealing
(supplied with receiver)
around the wire
harness in the place
where the wire harness
enter the unit.
Clamp the wire
harness to other
cables.
1 Remove the screw.
2 Insert the plastic band
(supplied with receiver).
The wire harness should
go through the clamp.
3 Put the screw back.
Field setting
If optional accessories are mounted on the indoor unit, the
indoor unit setting may have to be changed. Refer to the
instruction manual (option handbook) for each optional
accessory.
(See figure 4)
A Mode No.
B Field Set mode
C First code No.
D Second code No.
Procedure
1 When in normal mode, hold down the
button for
at least 4 seconds to enter the Field Set mode.
2 Select the desired Mode No. with the
button.
3 Press the button and select the First code No.
4 Press the
button and select the Second code No.
5 Press the
button to confirm the settings.
6 Press the
button to quit the Field Set mode and
to return to normal display again.
English
01_EN_3P444567-1.indd 5
7/5/2016 11:05:30 AM
