29
ON Timer mode setting
1
•
Press both the Fan Speed Control button ( )
and Temperature Setting (up) button (
)
simultaneously to enter timer mode setting.
The display “
” blinks.
2
• Press the Temperature Setting (up/down) button
(
/
) and set the time for starting the air
conditioner.
: When this button is pressed, the timer
advances by 1 hour.
: When this button is pressed, the timer
goes backward by 1 hour.
If set the time is “0”, it means that the timer
starting setting was cancelled.
3
• After selecting the time to start the air conditioner,
press the Fan Speed Control button ( ) to set it.
The timer setting procedure ends and the “
”
on the display changes from a flashing light to a
constant light.
Note:
• When setting the timer OFF and ON at the same time, repeat the above procedure (from 1 to 3)
once again.
• After the timer is programmed, the display shows the remaining time.
• For example
When the timer is programmed to stop the air conditioner after
3 hours and start the air conditioner after 4 hours, the air conditioner
will stop after 3 hours and then 1 hour later the air conditioner will
start.
•
Timer setting cannot be carried out if this remote controller has been set as a sub remote
controller [slave].
01_EN_4P543053-1C.indd 29
10-May-19 4:13:36 PM
