13
English
Reset of the display
Press OPERATION MODE SELECTOR BUT-
TON to get the display back to the normal
state.
II.
IN CASE BESIDES EMERGENCY STOP
1. The air conditioner does not operate at all.
• Check if the receiver is exposed of
sunlight or strong light. Keep receiver away
from light.
• Check if there are batteries in the remote
controller. Place the batteries.
• Check if the indoor unit number and wireless
remote controller number are equal.
Operate the indoor unit with the remote con-
troller of the same number.
Signal transmitted from a remote controller of
a different number cannot be accepted. (If the
number is not mentioned, it is considered as
“1”.)
2. The air conditioner operates but it does not
sufficiently cool or heat.
• Check if the set temperature is not proper.
(Refer to page 8)
• Check if the FAN SPEED is set to LOW
SPEED. (Refer to page 8)
• Check if the airflow direction is not proper.
(Refer to page 8, 9)
If the problem is not solved after checking the
above points, please do not try to repair it
yourself. In such cases, always consult your
local dealer. At this time, please tell the symp-
tom and model name (written on the manufac-
turer’s label).
Contact your local dealer in the following case.
WARNING
When you detect a burning odor, shut OFF
power immediately and contact your local
dealer. Using the equipment in anything but
proper working condition can result in equip-
ment damage, electric shock and/or a fire.
[Trouble]
The OPERATING INDICATOR LAMP of the indoor
unit is flashing and the unit does not work at all.
(Refer to page 4)
[Remedial action]
Check the malfunction code (A1 - UF) on the remote
controller and contact your local dealer. (Refer to
page 12)
7
MODE
Number
Number
MODE
TIMER
RESERVE CANCEL
DOWN
UP
/TEST
SWING
FAN
TIME
TEMP
ON OFF
UNIT N
O
.
CODE
Malfunction Code
Unit No. which
sensed trouble
INSPECTION
display
01_EN_3P302565-2D.fm Page 13 Sunday, September 30, 2012 1:30 PM
