Si-95
Test Operation
Test Operation Inverter K Series
45
1.3
Setting Modes
The three setting modes are as follows:
◆
Setting mode 1
..... Mode for selecting cool/heat setting method, and whether or not to use low noise
operation and sequential start.
(H1P off)
◆
Setting mode 2
..... Mode for changing operating status and setting addresses; used primarily for
service.
(H1P on)
◆
Monitor mode
..... Mode for checking setting made in the setting modes, number of connected units,
etc.
(H1P flickers)
Mode Changing
Procedure
The flow of the setting modes is as follows. (See the following pages for details.)
■
You can make your selections with the SET button
.
■
If you become unsure of how to proceed, push the MODE button and return to setting mode 1.
■
You don’t have to perform power supply reset after changing settings in setting mode 1 (including [SS1]
cool/heat selection switch on the outdoor unit PC board) and setting mode 2.
Push the MODE button.
Push
the MODE
button.
Push
the SET
button.
Push and hold the MODE button for 5 sec.
Push
the MODE
button.
Setting mode 1
(Initial setting)
Push
the RETURN
button.
Push
the RETURN
button.
Low noise operation
selection
Set
Sequential start
selection
Set
Push
the RETURN
button.
Push
the RETURN
button.
Contents display
Monitor item selection
Set
Monitor mode
Push
the RETURN
button.
Push
the RETURN
button.
Push
the RETURN
button.
Setting contents
display
Setting item selection
Set
Setting contents
selection
Set
Setting mode 2
(VF015)
Set
SI-95.BOOK Page 45 Friday, March 31, 2000 10:59 AM
