Mounting and commissioning
18
)$(.65'6$(1
6.3 Electrical connection
;
Mains voltage is interrupted and cannot be switched on.
1.
Connect the circulation pump described in the enclosed
operating instructions.
2.
Route the connection cable of the circulation pump
through a cable duct to the bottom and connect it to the
solar controller. Observe the operating instructions of the
solar controller.
3.
Standard shielded cable 3 x 1.5 mm² and up to Ø 10 mm
can be used to extend the connection cable.
6.4 Commissioning
(.65'6$
In the case of
(.65'6$
, filling is possible via the filling
and flushing valves at the flow meter.
1.
Attach a label in the vicinity of the discharge line or to the
safety valve with the following text:
"For safety reasons, liquid must be able to escape via
the discharge line during heating. Do not shut off!"
2.
Verify that all connections are tight.
3.
Set both ball valves to 45° position.
0°
Operation
–
open in the direc-
tion of flow of the solar liquid
45° Commissioning, filling, vent-
ing, flushing
–
both sides open
(backflow preventer not active)
90° Maintenance
–
closed
Fig. 6: Ball valves
Summary of Contents for EKSRDS2A
