10A6 + ESFVG02~10A6
Supp covering feet (with grille)
4PW17558-1
Installation manual
1
F
EATURES
Only FWV and FWM units can be mounted on the
supporting feet (e.g. in case it is impossible to mount the
unit to the wall). For FWV models it is possible to mount
the covering feet (e.g. for masking the hydraulic pipes
coming from the floor).
The height of the covering feet is 100 mm.
These options are only applicable for vertical installed
models.
Table
8
at the very end of this manual shows the names
of option kits for each unit in function of the unit size.
Depending on the type of unit, some of the supplied
parts will not be applicable.
Check out
figure 1
and verify which of the supplied parts
are applicable for installing the ordered option (marked
with
✓
).
I
NSTALLATION
1
Remove the filter fixed to the cabinet by means of 1/4
turn screws (see
figure 2
).
2
Remove the fixing screws of the cover cabinet (see
figure 3
).
3
Remove the cover cabinet.
4
Set the basic unit of the unit on its back.
5
Fit the supporting feet (left and right) onto the
respective sides of the basic unit (by means of
screws 4.2 x 13 mm (see
figure 4
)).
6
The covering feet may be installed indifferently (only
for FWV) on the right-hand or left-hand side of the
unit. The choice of the installation side is determined
by the short side of the foot that must be on the front
of the unit. Slightly tighten the self-tapping screws
into the specific holes drilled on the covering feet
(see
figure 5
).
7
Insert the head of the screws 2.9 x 9.5 mm into the
slots of the lower part of the side panels of the cover
cabinet. Make sure to align the internal profile of the
covering foot with the internal profile of the side
panels (see
figure 6
).
8
Tighten the screws.
9
Reassemble the cover cabinet.
10
Reassemble the filter.
11
Fit the front grille by securing it with 4 screws
(4.2 x 13 mm) (see
figure 7
). (Only for ESFVG.)
ESFV06A6
ESFVG02A6
ESFV10A6
ESFVG03A6
ESFVG06A6
ESFVG10A6
Supp covering feet
(with grille)
Installation manual
Read this manual attentively before starting up
the unit. Do not throw it away. Keep it in your
files for future reference.
Improper installation or attachment of
equipment or accessories could result in
electric shock, short-circuit, leaks, fire or other
damage to the equipment. Be sure only to use
accessories made by Daikin which are
specifically designed for the use with the
equipment and have them installed by a
professional.
If unsure of installation procedures or use,
always contact your Daikin dealer for advice
and information.
