10
|
Configuration
Installer reference guide
211
EPRA14~18D + ET23E
Daikin Altherma 3 H HT F
4P644739-1A – 2022.03
a
WLAN cartridge
The WLAN cartridge needs to be inserted in the
user interface. See the installation manual of the
WLAN cartridge.
WLAN module
The WLAN module needs to be installed by the
installer on the indoor unit (on the inside of the
front panel). See:
▪
Installation manual of the WLAN module
▪
Addendum book for optional equipment
b
Router
Field supply.
c
Smar app
The ONECTA app needs to be installed on the
user's smartphone. See:
http://www.onlinecontroller.daikineurope.com/
Configuration
To configure the ONECTA app, follow the in-app instructions. While doing this, the
following actions and information are needed on the user interface:
Mode
: Turn AP mode ON (= WLAN cartridge/module active as access point) or OFF.
#
Code
Description
[D.1]
N/A
Enable AP mode
:
▪
No
▪
Yes
Reboot
: Reboot the WLAN cartridge/module.
#
Code
Description
[D.2]
N/A
Reboot the gateway
:
▪
Back
▪
OK
WPS
: Connect the WLAN cartridge/module to the router.
#
Code
Description
[D.3]
N/A
WPS
:
▪
No
▪
Yes
INFORMATION
You can only use this function if it is supported by the software version of the WLAN,
and the software version of the ONECTA app.
Remove from cloud
: Remove the WLAN cartridge/module from the cloud.
#
Code
Description
[D.4]
N/A
Remove from cloud
:
▪
No
▪
Yes
Summary of Contents for ETVZ16E6V7
Page 281: ......
Page 282: ......
Page 283: ......
Page 284: ...4P644739 1A 2022 03 Copyright 2021 Daikin Verantwortung f r Energie und Umwelt...