D-EOMCP00104-14_01EN
Operating Manual
4/35
EWYD_BZ
1
SAFETY CONSIDERATIONS
1.1 General
Installation, start-up and servicing of equipment can be hazardous if certain factors particular to the installation are not
considered: operating pressures, presence of electrical components and voltages and the installation site (elevated plinths
and built-up up structures). Only properly qualified installation engineers and highly qualified installers and technicians,
fully trained for the product, are authorized to install and start-up the equipment safely.
During all servicing operations, all instructions and recommendations, which appear in the installation and service
instructions for the product, as well as on tags and labels fixed to the equipment and components and accompanying parts
supplied separately, must be read, understood and followed.
Apply all standard safety codes and practices.
Wear safety glasses and gloves.
Do not operate on a faulty fan, pump or compressor before the main switch has been shut off.
Overtemperature protection is auto-reset, therefore the protected component may restart
automatically if temperature conditions allow it.
In some unit a push button is placed on a door of the unit electrical panel. The button is highlighted by a red color in yellow
background. A manual pressure of the emergency stop button stops all loads from rotating, thus preventing any accident
which may occur. An alarm is also generated by the Unit Controller. Releasing the emergency stop button enables the
unit, which may be restarted only after the alarm has been cleared on the controller.
The emergency stop causes all motors to stop but does not switch off power to the unit. Do not
service or operate on the unit without having switched off the main switch.
1.2 Before switching the unit
Before switching on the unit read the following recommendations:
•
When all the operations and all the settings have been carried out, close all the switchbox panels
•
The switchbox panels can only be opened by trained personnel
•
When the UC requires to be accessed frequently the installation of a remote interface is strongly recommended
•
LCD display of the unit controller may be damaged by extremely low temperatures (see chapter 2.4). For this
reason, it is strongly recommended to never power off the unit during winter, especially in cold climates.
1.3 Avoid electrocution
Only personnel qualified in accordance with IEC (International Electrotechnical Commission) recommendations may be
permitted access to electrical components. It is particularly recommended that all sources of electricity to the unit be shut
off before any work is begun. Shut off main power supply at the main circuit breaker or isolator.
IMPORTANT: This equipment uses and emits electromagnetic signals. Tests have shown that the equipment
conforms to all applicable codes with respect to electromagnetic compatibility.
Direct intervention on the power supply can cause electrocution, burns or even death. This action
must be performed only by trained persons.
RISK OF ELECTROCUTION: Even when the main circuit breaker or isolator is switched off, certain
circuits may still be energized, since they may be connected to a separate power source.
RISK OF BURNS: Electrical currents cause components to get hot either temporarily or permanently.
Handle power cable, electrical cables and conduits, terminal box covers and motor frames with great
care.
ATTENTION: In accordance with the operating conditions the fans can be cleaned periodically. A fan
can start at any time, even if the unit has been shut down.
