3 About the tools
Installation manual
6
EZESHP20 EZLSHP20AUAW1B
Exigo E1500 Trailer Refrigeration Unit
4P726857-1 – 2023.03
DANGER: RISK OF BURNING/SCALDING
Allow the evaporator defrost heaters and the water
discharge heater to cool down before touching them.
DANGER: RISK OF ELECTROCUTION
▪ Turn OFF all power supply before removing the switch
box cover, connecting electrical wiring or touching
electrical parts.
▪ Disconnect the power supply for more than
60 seconds, and measure the voltage at the terminals
of main circuit capacitors or electrical components
before servicing. The voltage MUST be less than
50 V DC before you can touch electrical components.
For the location of the terminals, see the wiring
diagram.
▪ Do NOT touch electrical components with wet hands.
▪ Do NOT leave the unit unattended when the service
cover is removed.
WARNING
Never touch a person receiving an electrical shock, or you
could suffer one too. Do not touch the person until you are
sure power is turned off.
Electrical shocks always need emergency medical
attention, even if the victim seems to be fine afterwards.
DANGER: RISK OF ELECTROCUTION
The bottom plate, must be grounded via the unit's frame.
Connect the earth cable correctly to the frame.
CAUTION
The battery is set up in a small space, be careful not to
cause a short circuit during installation.
CAUTION
The battery is heavy and therefore difficult to handle.
WARNING
▪ After finishing the electrical work, confirm that each
electrical component and terminal inside the electrical
components box is connected securely.
▪ Make sure all covers are closed before starting up the
unit.
2.2.4
Engine
WARNING
Do no operate the unit in road mode (with diesel engine
running) in confined spaces and areas where fumes from
the engine could become trapped and cause serious injury
or death.
In confined spaces, use the dedicated function on the HMI
to disable automatic road mode start-up.
WARNING
Keep your hands, clothing and tools clear of moving parts
such as fans and engine belt when the unit is working.
DANGER: RISK OF BURNING/SCALDING
Allow the PM generator, the engine, the engine exhaust
and the engine- cooling system to cool down before
touching any of these parts.
3
About the tools
3.1
Tools required for installing the
unit
d
b
f
e
a
g
c
h
a
Torque wrench
b
Metric socket set
c
Metric Allen key set
d
Metric spanner set
e
Saw
f
Screwdrivers
g
Driller
h
Cutter for multilayer and pneumatic hoses
INFORMATION
Choose the correct saw in function of the wall thickness of
the cold room. Make sure the blade is long enough to cut
through the entire wall panel.
4
About the box
Keep the following in mind:
