background image

9

English

7. OPTIMUM OPERATION

Observe the following precautions to ensure the 
system operates.

Prevent direct sunlight from entering a room 
during COOLING OPERATION by using curtains 
or blinds.

Keep doors and windows closed. If the doors and 
windows remain open, room air will flow out and 
decrease the effect of cooling and heating.

Never place objects near the air inlet and the air 
outlet of the unit. It may deteriorate the effect or 
stop the operation.

Adjust the room temperature properly for a com-
fortable environment. Avoid excessive heating or 
cooling.
Not doing so wastes electricity.

When the display shows “

” or “Time to clean 

filter”, ask a qualified service person to clean the 
filters. 
(Refer to “MAINTENANCE” on page 9.) 
Operating the unit with stained air filter may 
decrease capacity or cause malfunction.

Install TVs, radios, and stereos 1 m or more away 
from the indoor unit and remote controller.
Images may become fuzzy and noise may be 
generated.

Turn off the power circuit breaker when it is not in 
use for a long period. When the power circuit 
breaker is turned on, small amount of power is 
consumed even if the system is not in operation. 
(*1) Turn off the power circuit breaker for saving 
energy. When reoperating, turn on the power cir-
cuit breaker 6 hours before operation for smooth 
running.
(Refer to “MAINTENANCE” on page 9.) (*2)
*1 The consumed power while the outdoor unit is 

not in operation depends on the model.

*2 The setting before the power circuit breaker is 

cut off is stored. (The timer setting is cleared.)

Fully use the function of airflow direction adjust.
Cold air gathers on the floor, and warm air gathers 
in the ceiling.
Set the air discharge to horizontal direction during 
COOLING or PROGRAM DRY OPERATION, and 
set it downwards during HEATING OPERATION.
Do not let the air blow directly to a person.

Use the TIMER OPERATION effectively.
It takes some time until the indoor temperature 
reaches the set temperature. It is advisable to 
start operation in advance using TIMER OPERA-
TION.

8. MAINTENANCE

(FOR SERVICE PERSONNEL)

ONLY A QUALIFIED SERVICE PERSON IS 
ALLOWED TO PERFORM MAINTENANCE

WARNING

Do not use flammable gas (such as hair sprays 
and insecticides) near the air conditioner.
Do not wipe the indoor unit with benzine or thin-
ner.
This may cause cracking, electric shock, or fire.

CAUTION

Do not wash the air conditioner with water.
Doing so may result in an electric shock and fire.

To clean the air conditioner, be sure to stop oper-
ation, and turn the power circuit breaker off. It may 
cause electric shock or injury.

Be careful of your footing when working at high 
places.
Unstable footing may cause the person to fall and 
get injured. 

NOTE

Do not remove the air filter except for during 
cleaning. Doing so may damage the unit.

Do not install anything (such as kitchen paper) 
other than the approved air filters on the air inlet. 
Doing so may lower operation efficiency and 
cause freezing or leakage.

HOW TO CLEAN THE AIR FILTER

When the remote controller indicates “

” or “Time 

to clean filter”, clean the air filter.

It indicates after running for a certain time.

NOTE

The time until the display appears can be 
changed. For information on using the air condi-
tioner in a dirty place, contact your dealer.

Stain

Time until display 

appears

Standard

200 hours

(approx. 1 month)

When the amount of 

staining is large

100 hours

(approx. 2 weeks)

4PEN465287-1C.book  Page 9  Thursday, March 23, 2017  2:47 PM

Summary of Contents for FAA71AUVEB



















Reviews: