13
English
(1) For rear side piping
•
Remove the rear piping penetration cover, and connect the piping.
(Refer to Fig. 16 and Fig. 18)
(2) For upward piping
•
For upward piping, L-shaped connection piping kit (optional accessory) will be required.
•
Remove the top panel penetration cover, and use the L-shaped connection piping kit (optional acces-
sory) to conduct piping.
(Refer to Fig. 16 and Fig. 17)
(3) For right side piping
•
Remove the stay for packing and delivering (reinforcing plate) at the right side, and put back the screw
to the original position of the indoor unit.
(Refer to Fig. 18)
•
Open the knockout hole at the decoration side panel (right), and connect piping.
(Refer to Fig. 18)
Top panel penetration cover
Cut at the position avoiding
the knob part of the penetration
cover
Rear piping penetration cover
View from air inlet side
Cutoff
Cutoff
Top panel
Fig. 16
Upward refrigerant piping
L-shaped branch piping kit
(Optional accessory)
Fig. 17
Screw
(put back to the indoor unit)
Decoration side panel (right)
Separating parts
Cut only this part when
laying only the drain
piping on the right side.
Stay for packing and delivering
(reinforcing plate)
Right side refrigerant piping
Rear side drain piping
Rear side refrigerant piping
Right side drain piping
Fig. 18
01_EN_3P249378-6L.fm Page 13 Sunday, September 30, 2012 2:30 PM