11
English
2
Keep holding the clips at the upper part of the
suction grille and pull them to frontward.
3. Take out the air filter.
Refer to the Clause 2 for “
HOW TO CLEAN THE
AIR FILTER
”. (page 10)
4. Clean the suction grille.
Wash the suction grille with water or neutral
detergent using a soft brush and then dewater it.
When the suction grille is extremely contaminated
•
Spray the detergent for a ventilating fans and
ranges directly to the grille, and keep them under
that condition for about 10 minutes.
After that, carefully wash the suction grille with
water.
NOTE
• Do not wash the suction grille with water of
50°C or higher.
It may cause discoloration and deformation.
• When drying the suction grille, do not heat it
with fire. It may cause burning.
• Do not use such as gasoline, benzine, thinner,
polishing powder and liquid insecticide sold
in the market.
It may cause discoloration and deformation.
5. Attach the air filter.
Refer to the Clause 4 for “
HOW TO CLEAN THE
AIR FILTER
”. (page 10)
6. Attach the suction grille.
Attach the grille in the reverse order mentioned
in the Clause 2.
Clip
Clips
FHQ35·50
FXHQ32
: 2 places
: 3 places
FHQ60·71·100·125·140
FXHQ63·100
Detergent
7. Close the suction grille.
Slide all the knobs in the reverse order men-
tioned in the Clause 1 and securely fix them.
HOW TO CLEAN AIR OUTLET, OUTSIDE
PANEL, AND REMOTE CONTROLLER
•
Wipe them with a dry soft cloth.
•
When the stain cannot be wiped off, dip the cloth
in the neutral detergent diluted with water and
twist the cloth. After wiping off stain with this cloth,
wipe them with dry cloth.
NOTE
• Do not use such as gasoline, benzine, thinner,
polishing powder and liquid insecticide sold
in the market.
It may cause discoloration and deformation.
• Do not wash the filter with warm water of 50°C
or higher. It may cause discoloration and
deformation.
CLEANING BEFORE AND AFTER SEA-
SONAL USE
WHAT TO DO WHEN START UP AFTER A
LONG STOP
Confirm the following
•
Check that the air inlet and outlet of indoor and
outdoor unit are not blocked.
Remove any obstacle.
Obstacles decrease the fan speed, and cause
performance decrease and breakage of the
devices.
Clean the air filter
•
After cleaning the air filter, make sure to attach it.
(Refer to “
8. MAINTENANCE
” on page 9.)
•
For information on how to install, remove, or clean
a optional sold air filter, refer to the user’s manual
attached to the air filter.
•
Turn off the indication “
” or “Time to clean fil-
ter” displayed on the remote controller after turn-
ing on the power.
The indication can be turned off whether in oper-
ation or at stop.
<In case of BRC1E, BRC1D>
•
For details, refer to the operation manual
attached to the remote controller.
<In case of BRC1C>
•
Press FILTER SIGN RESET button.
Turn on the power circuit breaker at least 6
hours before operation.
•
This is required in order to activate the air condi-
tioner smoothly, and to protect air conditioner.
•
The display on the remote controller will be shown
when the power circuit breaker is turned on.
01_EN_3P303408-2N.fm Page 11 Thursday, February 20, 2014 3:49 PM
