English
■
4
Indoor Unit Installation Diagram
CAUTION
• Do not hit or violently push the INTELLIGENT EYE sensor. This can lead to damage and malfunction.
• Do not place large objects near the INTELLIGENT EYE sensor. Also keep heating units or humidifiers outside the sensor’s
detection area.
1) Insert the tool into the groove of the front grille fixture.
How to remove front grille fixture
2) Turn the tool 90° in the direction of the arrow.
3) Take out the front grille fixture.
1-3/16” (30mm) or more
from ceiling
Wrap the insulation
pipe with the finishing
tape from bottom to
top.
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that
no gap is left in the
insulation pipe’s cut
line.
Caulk pipe hole gap
with putty.
Mounting plate
A
Mounting plate fixing
screws M4 × 1” (M4 × 25mm)
B
INTELLIGENT EYE
sensor
1-15/16” (50mm)
or more from walls
(on both sides)
Front panel
M4 × 5/8”
(M4 × 16mm)
M4 × 5/8”
(M4 × 16mm)
M4 × 5/8”
(M4 × 16mm)
Air filters
The service lid is
removable.
Opening method
1) Remove the
service lid
screws.
2) Pull out the
service lid
diagonally
down in the
direction of the
arrow.
3) Pull down.
Service lid
Bottom of indoor unit
Front grille fixture
Screw covers (3)
J
Remote controller
holder fixing screws
M3 × 13/16”
(M3 × 20mm) (2)
F
C Titanium apatite photocatalytic
air-purifying filter (3)
Titanium apatite photocatalytic
air-purifying filter
Filter frame
Air filter
Tab
Front grille fixture
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
A
D Wireless
remote
controller
E Remote
controller
holder
Before screwing
the remote
controller holder
to the wall, make
sure that control
signals are
properly received
by indoor unit.
E
How to attach the indoor unit
Hook the hooks of the bottom frame
to the mounting plate.
If the hooks are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the hooks. If it is difficult
to release, remove the front grille.
A
A Mounting
plate
Hook
Mark
(rear side)
Mark
(rear side)
Front grille
Bottom
frame
01_EN_3P457790-1.fm Page 4 Thursday, December 1, 2016 3:51 PM
