1-11
English
Mounting Installation Plate
Ensure that the wall is strong enough to withstand the weight
of the unit. Otherwise, it is necessary to reinforce the wall
with plates, beams or pillars.
Use the level gauge for horizontal mounting, and
fi
x it with
5 suitable screws for FTXK/FTKK 09/12 and 7 suitable
screws for FTXK/FTKK 18/24.
In case the rear piping draws out, drill a hole 2-9/16” (65mm)
in diameter with a cone drill, slightly lower on the outside
wall (see
fi
gure).
FTXK/FTKK 18/24
FTXK/FTKK 09/12
Mounting plate
Mounting plate
Mounting plate
fi xing screw
Mounting plate
fi xing screw
Drilling a Wall Hole and Installing Wall Embedded
Pipe
Hole with Cone Drill
Outside
Caulking
Ø 2-9/16” (65mm)
Wall embedded pipe
(Field supply)
Inside
Wall embedded pipe
(Field supply)
Wall- mounting
frame
Mount The Unit Onto The Installation Plate
Hook the indoor unit onto the upper portion of the installation
plate (Engage the two hooks at the rear top of the indoor unit
with the upper edge of the installation plate). Ensure that the
hooks are properly seated on the installation plate by moving
it to the left and right.
How To Attach The Indoor Unit
Hook the claws of the bottom frame to the mounting plate.
How To Remove The Indoor Unit
Push up the marked area (at the lower part of the front
grille) to release the claws.
Mounting plate
Clip
Bottom frame
Mark (Rear side)
Mounting plate
Hand indoor unit’s hook here.
When stripping the ends
of interconnecting wires in
advance, bind right ends of
wires with insulating tape.
Interconnecting
wires
Wire guide
Front grille
Water Drainage Piping
The indoor drain pipe must be in a downward gradient for
smooth drainage. Avoid situations that are likely to cause
water to leak.
Water Drainage
Correct
Wrong
Water
leaking
Water
leaking
Drain
Water
leaking
Water
retention
End
dipped
into
water
Wrong
Wrong
CAUTION
• Do not install the unit at altitude over 6560ft (2000m)
for both indoor & outdoor.
IM-5WMYJ(R)-1117(0).indb 11
IM-5WMYJ(R)-1117(0).indb 11
3/7/2018 8:54:10 AM
3/7/2018 8:54:10 AM