9
■
English
Indoor Unit Installation
4-4. Wall embedded piping.
Follow the instructions given under
.
1) Insert the drain hose to this depth so it won’t be
pulled out of the drain pipe.
WARNING
Do not bundle the power code with a binding band, a twist tie or other method.
This may cause heat, electric shock or fire.
5.
Humidifying hose installation work.
5-1. Connecting to the indoor unit.
• Connect the cuff side of the humidifying hose to the indoor unit duct.
CAUTION
Use caution not to deform the cuff while installing the humidifying hose.
5-2. Connecting the cut humidifying hoses.
• When install the cut humidifying hoses, follow the instructions below.
• Use not more than two elbows to ensure humidifying capacity.
Inner wall
Vinyl chloride
drain pipe
(VP-30)
Drain hose
50mm
or more
Outer wall
Insert drain hose
to this depth so
it won’t be pulled
out of drain pipe.
Left-side, left-back, or left-bottom piping
Insert as far as possible
so that there are no gaps.
Cut the cuff
at this part.
• Left-back piping
It is easier to connect the hose
with the front grille removed.
Cuff
Humidifying
hose
Connect the
cuff side of the
humidifying
hose to the
indoor unit duct.
The protrusion of the
humidifying hose from the
wall hole is about 100mm.
(If it is too long, cut the humidifying hose
and bond the separately sold cuff with
adhesive for vinyl to adjust the length.)
Pulling out the
humidifying hose in a
downward direction.
Pulling out the
humidifying hose in a
sideward direction.
Approx. 100mm
Apply the binding band
at 10mm from the rim
of the joint to prevent
the humidifying hose
from coming off.
Insert each humidifying
hose to the rim of the joint
so that there are no gaps.
Apply the binding band at 10mm
from the rim of the elbow to
prevent the humidifying hose
from coming off.
Insert each humidifying
hose to the rim of the elbow
so that there are no gaps.
Elbow
Joint
01_EN_3P177302-1.fm Page 9 Tuesday, May 30, 2006 9:36 AM
Summary of Contents for FTXR28EV1B
Page 17: ... 0605 HT 3P177302 1 M05B200 ...
