Daikin FTXR28EV1B, Installation Manual

3

■

English

Indoor Unit Installation Drawings

2.

Removing and installing indoor unit. 

• Installation method 

1) Using the   marks (3 locations) on top of the 

indoor unit, attach the   mounting plate hooks 
onto the indoor unit. 

2) Attach the tabs on the bottom frame onto the 

 mounting plate. If the tabs are not hooked onto 

the plate, remove the front grille to hook them. 
(Check to see if the tabs are hooked securely.)

• Removal method 

Push up the mark part on the bottom of the front 
grille, discharge the tabs, and then remove the unit 
while lifting it up.

Tab

Bottom 
frame

Mark
(rear side)

A

Mounting 
plate

To remove the unit, push up the bottom of the bottom 
frame with your fingers to free tabs. 
(Mark parts (2 locations) on the bottom of the front grille.)

A

Mounting 
plate

A

A

 H  
Remote 
controller holder

Screws 
(Field supply: M3 × 20L)

Air supply 
filter

D

Wrap the insulation 
pipe with the finishing 
tape from bottom to top.

Install the 
hose with a 
downward 
slope.

Do not install the trap to 
the humidifying hose as 
much as possible.

If it is difficult to lay the humidifying 
hose, cut it, lay it, and connect it 
using the joint or elbow included 
with the outdoor unit. 

Cut thermal insulation pipe 
to an appropriate length and 
wrap it with tape, making 
sure that no gap is left in the 
insulation pipe’s cut line.

30mm or more 
from ceiling

50mm or more 
from walls 
(on both sides)

Screws 
(Field supply: M4 × 25L)

A

Mounting plate

The      mounting plate 
should be installed on a 
wall which can support the 
weight of the indoor unit.

Use when 
opening the 
front panel and 
securing.

Supporting plate

Supporting plate

How to open the service lid

Front panel

Air filter

2)

1)

The service lid is 
removable.

n

 Opening the lid

1) Remove the screws 

on the service lid.

2) Hold the knobs on the 

service lid and pull 
forward.

Humidifying 
hose

Before screwing the 
remote controller 
holder to the wall, 
make sure that control 
signals are properly 
received by indoor unit.

C

Titanium apatite 
photocatalytic 
air-purifying filter

B

Deodorizing filter 
for streamer

Hook

G

Wireless 
remote controller

Set the 
     batteries.

J

The securing tape is applied. 
Be sure to remove it before 
installation.

A

01_EN_3P177302-1.fm  Page 3  Tuesday, May 30, 2006  9:36 AM