Daikin FTYN25GV1A, Operation Manual

18

1. Open the front panel. (page 17.)
2. Pull out the air filters.

• Push a little upwards the tab at the center of each air 

filter, then pull it down. 

3. Take off the Titanium Apatite Photo-

catalytic Air-Purifying Filter.

• Hold the recessed parts of the frame and unhook 

the four claws.

4. Clean or replace each filter.

See figure.

5. Set the air filter, Titanium Apatite 

Photocatalytic Air-Purifying Filter as 
they were and close the front panel.

• Insert claws of the filters into slots of the front panel. 

Close the front panel slowly and push the panel at the 
3 points. (1 on each sides and 1 in the middle.)

■

Air Filter

1. Wash the air filters with water or clean them with 

vacuum cleaner.

• If the dust does not come off easily, wash them with neutral detergent 

thinned with  lukewarm water, then dry them up in the shade.

• It is recommended to clean the air filters every two weeks.

■

Titanium Apatite Photocatalytic 
Air-Purifying Filter.

The Titanium Apatite Photocatalytic Air-Purifying Filter can be renewed 
by washing it with water once every 6 months. We recommend replacing 
it once every 3 years.

[ Maintenance ]

1. Remove dust with a vacuum cleaner and wash lightly with water.

2. If it is very dirty, soak it for 10 to 15 minutes in water mixed with a neutral cleaning agent.

3. Do not remove filter from frame when washing with water.

4. After washing, shake off remaining water and dry in the shade.

5. Since the material is made out of paper, do not wring out the filter when removing water from it.

[ Replacement ]

1. Remove the tabs on the filter frame and replace with a new filter.

• Dispose of the old filter as flammable waste.

Filters

Air filter

Titanium Apatite 
Photocatalytic 
Air-Purifying Filter

Filter frame

Tab

Push

Tab

01_EN_3P232468-8.fm  Page 18  Wednesday, June 4, 2008  10:33 AM