18
TIMER Operation
To use ON TIMER operation
•
Check that the clock is correct.
If not, set the clock to the present time.
Page 9
1.
Press
.
” is displayed.
” blinks.
“
“
•
“
” and day of the week disappear from the LCD.
2.
Press
until the time setting reaches the
point you like.
• Each pressing of either button increases or decreases the time setting by 10 minutes.
Holding down either button changes the setting rapidly.
3.
Press
again.
•
“ ” and setting time are displayed on the LCD.
• The TIMER lamp lights yellow.
Control panel
To cancel ON TIMER operation
Press
.
•
“ ” and setting time disappear from the LCD.
•
“
” and day of the week are displayed on the LCD.
• The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2 timers is shown below.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00 Combined
ATTENTION
In the following cases, set the timer again.
•
After a breaker has turned off.
•
After a power failure.
•
After replacing batteries in the remote controller.
01_EN_3P705032-9.indd 18
30/08/2022 1:18:03 pm
